RSTH-HU31022

Product information

Test cable set for diagnosis

Complete wiring harness for vehicle diagnosis.
Contains almost all connecting pipes for connection to sensors, valves, connections, nozzles, valves, injectors.
All cables are carefully sorted by plug and plug pairs and terminal size.
Includes ATC fuse adapter Mini and Maxi and ATC current loop for use with an alligator clip.
Includes extra pointed cable piercers. This innovative design provides sufficient holding power to penetrate the cable insulation.
New variable resistor with 10 kΩ (instead of 5kΩ) dial meter. Quick and easy way to adjust resistance without the help of a multimeter when simulating sensor units for resistance measurements.
Airbag Simulator: Used to confirm the power consumption of SRS airbags by first connecting them to check for short circuits before installing a new SRS.
Interchangeable resistors! 3 of 2 Ohm - 2.2 Ohm - 2.7 Ohm.
LED Strobe: For checking the correct wiring of the terminal blocks. Also for comparing pulses or signals between injectors. LED lights up red when polarity is reversed. LED lights up green when polarity is correct.
Also includes common components such as alligator clips, banana plugs for use with multimeters, 3-way extension plugs or removable test tips.
Ultra-thin cable for multi-pin connectors


Kit the files the test diagnostic automotive
Depending on the need for connectors for injectors, connectors.
Tous les fils sont disposés correctement en pairses « male et femelle » et par taille de borne
Comprend with an ATC adapter for fusible mini and maxi and current ATC utilisers with a few ampere triques
Comprend des sondes à pointe supplémentaires. This innovative design applies a force to maintain suffisante to ensure the insulating gain of the filtration
New resistance variable of 10KΩ (au lieu of 5KΩ) with indication. The use of a rapid resistance adapter without aiding a multimeter pendant with the simulation of resistance detection equipment
Airbag Simulator: Used to confirm the maintenance of the SRS airbag and the connector to verify the presence of the court circuits before installing a new SRS
Resistances remplaceable! 3 the 2 ohms - 2.2 ohms - 2.7 ohms
Stroboscope à LED : Pour verifier des éries de borenes en vue d\'un câblage correct. Method for comparison of the impulses of the signs between injectors. La LED devient rouge en cas de polarité inverse. La LED devient verte en cas de polarité correcte
Comprend also with the composants standards comme des tweezers crocodile, une prize banane à utiliser avec de multimetres, des prises d\'extension 3 voies ou des sondes de test amovibles
Fiches ultra fines pour connecteurs multiples